I've noticed for the last couple of updates that my tab/tab settings seem to carry over when i start a new map, and even occasionally when i load GameGuru from a fresh start.
Anyone else had this issue?
Steps:
1. Create a map
2. Enter test mode
3. Change the settings in tab/tab
4. Exit test mode
5. Create a new map
6. Enter test mode
The settings from the previous map will now be active on the new map.
As i said, this happens almost all the time when you create a new map, and every now and then when you close down GameGuru and load it again.
Is this a bug?
Or has it been changed to do this?
If it has been changed to do this is there a way to disable it from doing it? Because it is REALLY annoying. I do a lot of messing about with the settings, and sometimes you can mess around too much and it's just easier to start a new level to bring it back to default and start over, but with it like this you can't do that.
Primary Desktop:
i7 7700,k NV1070 8GB, 16GB 3200mhz memory, 1x 2TB Hybrid, Win10.
Secondary Desktop:
i5 4760k, NV960 2GB, 16GB 2333mhz memory, 1x 2TB Hybrid, Win10.
Laptop:
i3, Intel 4000 series graphics, 6GB memory, 1x 500gb HDD, Win8.1.