I would like to be able to set the objects in grid view not only in the division 100 unit.
As an example:
Object does not look like a cube, has jagged edges and its size less than 100 unit (eg 70 unit ).
Put the same object with such a well GRID mode does not go. When you switch to SNAP mode some elements of the canopy-type object, or protruding bricks or the like also does not allow to put the object near accurate.
Here on this and I would like to have a separation grid mode 4 sub-modes.
Assume a grid with dimensions of 1 unit ; 5 unit ; 10 unit ; 100 unit.

Simply, you can switch to the normal mode and to adjust to one another during the installation of one or two objects. But if you want to install 20-30 objects it takes a lot of time and is not very convenient.

Do not you think that it is useful ?

The new EBE (Easy Building Editor) design has been mulling the same idea over. Maybe you can email me directly at lee@thegamecreators.com and we can discuss what an artist would like to see in a super-easy building maker

Ok Lee. Later, I'll post a email. We'll discuss it.